2005 Nissan X-Trail - Supplemental Restraint System (Section SRS) (50 pages)

Posted on 28 Mar, 2015 by Zepid
Model: 2005 Nissan X-Trail
File size: 1.46 MB


Other 2005 Nissan X-Trail Manuals:


Download manual 2005 Nissan X-Trail

Manual Description
(SRS) AIR BAG” and SEAT BELT PRE-TENSIONER” 3, precautions for SRS AIR BAG” SEAT BELT, wiring Diagrams Trouble Diagnosis 3, front Seat Belt Pre-tensioner with Load Limiter 6.

FOR QUICK AND ACCURATE REPAIR 8, wiring Diagram — SRS — /LHD models11, wiring Diagram — SRS — /RHD models 13, hOW TO ERASE SELF-DIAGNOSIS RESULTS 16.

WARNING LAMP FLASH CODE CHART 25, trouble Diagnosis: AIR BAG” Warning Lamp Does, fRONT PASSENGER AIR BAG MODULE 35, fRONT SIDE AIR BAG MODULE 37.

SIDE AIR BAG (SATELLITE) SENSOR 39, dISPOSAL OF AIR BAG MODULE AND SEAT BELT, caution for Air Bag Module and Seat Belt Pre-tensioner 42, mODULE (OUTSIDE OF VEHICLE) 43.

BELT PRE-TENSIONER (OUTSIDE OF VEHICLE) 46, dEPLOYMENT OF AIR BAG MODULE AND, dISPOSING OF AIR BAG MODULE AND SEAT, wHEN SRS (EXCEPT THE FRONT SIDE AIR.

BAG) IS ACTIVATED IN A COLLISION:48, wHEN SRS IS NOT ACTIVATED IN A COLLISION:48, wHEN THE SIDE AIR BAG IS ACTIVATED IN, wHEN SRS IS NOT ACTIVATED IN THE SIDE.

Precautions for Supplemental Restraint System (SRS) AIR BAG” SEAT, the Supplemental Restraint System such as AIR BAG” and SEAT BELT PRE-TENSIONER”, used along, with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger certain, to avoid rendering the SRS inoperative, which could increase the risk of personal injury death.

Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system, do not use electrical test equipment on any circuit related to the SRS unless instructed, precautions for SRS AIR BAG” and SEAT BELT PRE-TENSIONER” Service, do not use electrical test equipment to check SRS circuits unless instructed to Service Manual.

Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait least 3 minutes, for approximately minutes after the cables are removed, it is still possible for the air bag seat belt SRS, diagnosis sensor unit must always be installed with their arrow marks ⇐” pointing towards front, the spiral cable must be aligned with the neutral position since its rotations are limited.

Turn steering wheel or column after removal steering gear, side facing upward and place front side air bag module standing with stud bolt side setting bottom, conduct self-diagnosis to check entire SRS for proper function after replacing any components, after air bag inflates, the front instrument panel assembly should be replaced damaged.

When you read wiring diagrams, refer following, "How to Read Wiring Diagrams" GI section, "POWER SUPPLY ROUTING" PG section, when you perform trouble diagnosis, refer following.

"HOW TO FOLLOW TEST GROUPS IN TROUBLE DIAGNOSES" GI section, "How to Perform Efficient Diagnosis for an Electrical Incident" GI section, check for any service bulletins before servicing vehicle, disposing of air bag module front seat.

And front passenger air bag module, the collision modes for which supplemental restraint systems are activated are different among the SRS systems, sRS configurations which are activated for some collision modes follows, front LH side air bag module.

Front RH side air bag module, front Seat Belt Pre-tensioner with Load Limiter, the seat belt pre-tensioner system with load limiter installed.

Use of Cookies    About    Contact us
All marks are the property of their respective holders