Download manual 2011 Nissan SentraManual Description
(SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" 3, precaution Necessary for Steering Wheel Rotation After Battery Disconnect 3, precaution for Working with HFC-134a (R-134a) 4, precaution for Leak Detection Dye 5.
Precaution for Service Compressor 10, component Parts Harness Connector Location28, front Air Control Terminal Reference Value37, power Supply and Ground Circuit Front Air.
Maintenance of Oil Quantity Compressor 19, hEATER & COOLING UNIT ASSEMBLY 74, overview Air Conditioner LAN Control System 22, how to Perform Trouble Diagnosis Quick.
AIR MIX DOOR MOTOR 79, removal and Installation Compressor MR20DE 89, removal and Installation Compressor QR25DE 90, removal and Installation for Low-Pressure Flexible Hose Muffler Pipe 91.
Removal and Installation for High-pressure Flexible Hose 91, removal and Installation High-pressure Pipe 91, removal and Installation Refrigerant Pressure, removal and Installation Condenser 92.
Removal and Installation Evaporator 93, removal and Installation Expansion Valve 94, checking System for Leaks Using Fluorescent, service Data Specification (SDS) 98.
Precaution for Supplemental Restraint System (SRS) "AIR BAG" "SEAT BELT, the Supplemental Restraint System such as AIR BAG” and SEAT BELT PRE-TENSIONER”, used along, with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger certain, system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front.
Air bag, depending on the severity of a collision and whether the front occupants belted unbelted, information necessary to service the system safely is included in the SRS and SB section Service Manual, to avoid rendering the SRS inoperative, which could increase the risk of personal injury death, the event of a collision which would result in air bag inflation, all maintenance must be performed by.
Improper maintenance, including incorrect removal and installation of the SRS, can lead personal, injury caused by unintentional activation of the system, pRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS, when working near the Airbag Diagnosis Sensor Unit or other Airbag System sensors with IgniI.
Tion ON or engine running, DO NOT use air or electric power tools or strike near sensor(s) with, when using air or electric power tools or hammers, always switch the Ignition OFF, disconnect MTC, battery, and wait at least 3 minutes before performing any service, precaution Necessary for Steering Wheel Rotation After Battery Disconnect.
This Procedure is applied only to models with Intelligent Key system and NATS (NISSAN ANTI-THEFT SYSTEM), remove and install all control units after disconnecting both battery cables with the ignition knob, always use CONSULT-III to perform self-diagnosis as a part of each function inspection after finishing work, if DTC is detected, perform trouble diagnosis according self-diagnostic results.
For models equipped with the Intelligent Key system and NATS, an electrically controlled steering lock mechanism is adopted key cylinder, for this reason, if the battery is disconnected or if the battery is discharged, the steering wheel will lock, steering wheel rotation will become impossible, if steering wheel rotation is required when battery power is interrupted, follow procedure below before.
Supply power using jumper cables battery discharged, when removing or disassembling each component, be careful not to damage or deform it, may be subject to interference, be sure to protect it with shop cloth, when removing (disengaging) components with a screwdriver or similar tool, be sure wrap component.
With a shop cloth or vinyl tape protect it, protect the removed parts with a shop cloth keep them, replace a deformed damaged clip.