Download manual 2002 Nissan QuestManual Description
HEADLAMP (FOR CANADA) - DAYTIME LIGHT, tURN SIGNAL AND HAZARD WARNING LAMPS63, wiring Diagram - CHIME - 111, wiring Diagram - WIP/R - /Except Glass.
Wiring Diagram - WIP/R - /For Glass Hatch, schematic - Midgrade Premium System139, wiring Diagram - AUDIO - /Base System140, wiring Diagram - AUDIO - /Midgrade.
Wiring Diagram - MIRROR - /Without Automatic, smart Entrance Control Unit Inspection Table308, supplemental Restraint System (SRS) AIR BAG” SEAT BELT PRE-TENSIONER”, the Supplemental Restraint System such as AIR BAG”and SEAT BELT PRE-TENSIONER” used along with.
A seat belt, helps to reduce the risk or severity of injury to the driver and front passenger certain types, steering wheel), front passenger air bag module (located on the instrument panel passenger side), seat, belt pre-tensioners, a diagnosis sensor unit, warning lamp, wiring harness spiral cable, information necessary to service the system safely is included in the RS section Service Manual.
¼ To avoid rendering the SRS inoperative, which could increase the risk of personal injury death, ¼ Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system, when you read wiring diagrams, refer following, ¼ HOW TO READ WIRING DIAGRAMS”.
¼ POWER SUPPLY ROUTING” power distribution circuit, when you perform trouble diagnosis, refer following, ¼ How to Follow Test Group Trouble Diagnoses”, ¼ HOW TO PERFORM EFFICIENT DIAGNOSIS FOR AN ELECTRICAL INCIDENT”.
Check for any Service bulletins before servicing vehicle, the actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here, used to test Homelinkா Universal Transceiver, *: Special tool commercial equivalent.
The tab-locking type connectors help prevent accidental looseness disconnection, the tab-locking type connectors are disconnected by pushing or lifting locking tabs, refer to the next page for description slide-locking type connectors, a new style slide-locking type connector is used on certain systems components, especially those.
¼ The slide-locking type connectors help prevent incomplete locking and accidental looseness disconnection, ¼ The slide-locking type connectors are disconnected by pushing pulling slider, nORMAL OPEN, NORMAL CLOSED AND MIXED TYPE RELAYS, relays can mainly be divided into three types: normal open, normal closed mixed type relays.
BATTERY POWER SUPPLY — IGNITION SW, for detailed ground distribution information, refer GROUND DISTRIBUTION”, EL-20, wiring Diagram — POWER — (Cont'd), aCCESSORY POWER SUPPLY — IGNITION SW.
IGNITION POWER SUPPLY — IGNITION SW, if fuse is blown, be sure to eliminate cause problem, do not partially install fuse; always insert it into fuse, remove fuse for ELECTRICAL PARTS (BAT)” vehicle.
Not used for a long period time, a melted fusible link can be detected either by visual inspection, ¼ If fusible link should melt, it is possible that critical circuit, (power supply or large current carrying circuit) shorted.
In such a case, carefully check eliminate cause, ¼ Never wrap outside of fusible link with vinyl tape, for example, when current is 30A, the circuit is broken within 8, to remove combination switch base, remove base attaching.
Component Parts Harness Connector Location, the headlamps are controlled by headlamp control unit, power is supplied all times.