2012 Nissan Juke - LAN System (Section LAN) (142 pages)

Posted on 25 Mar, 2015 by Hurrdurr
Model: 2012 Nissan Juke
File size: 1.34 MB


Other 2012 Nissan Juke Manuals:


Download manual 2012 Nissan Juke

Manual Description
CAN COMMUNICATION SYSTEM : System Description 6, dIAG ON CAN : Description 6, dIAG ON CAN : System Diagram 6, symptom When Error Occurs in CAN Communication System 9.

(SRS) "AIR BAG" "SEAT BELT PRE-TENSIONER"21, cAN COMMUNICATION SYSTEM : System Diagram24, cAN COMMUNICATION SYSTEM : System Description24, cAN COMMUNICATION SYSTEM : CAN Communication Control Circuit26.

CAN COMMUNICATION SYSTEM : CAN System, cAN COMMUNICATION SYSTEM : CAN Communication Signal Chart28, hOW TO USE THIS MANUAL 20, mAIN LINE BETWEEN IPDM-E AND DLC.

MAIN LINE BETWEEN DLC AND A-BAG CIRCUIT 54, mAIN LINE BETWEEN DLC AND A-BAG CIRCUIT 36, mAIN LINE BETWEEN DLC AND MDU CIRCUIT 37, mAIN LINE BETWEEN DLC AND MDU CIRCUIT 67.

MAIN LINE BETWEEN DLC AND MDU CIRCUIT 96, mAIN LINE BETWEEN DLC AND A-BAG CIRCUIT82, mAIN LINE BETWEEN DLC AND A-BAG CIRCUIT 112, mAIN LINE BETWEEN DLC AND MDU CIRCUIT 127.

Use a tester with open terminal voltage of 7, turn the ignition switch OFF and disconnect the battery cable from negative terminal when, solder the repaired area and wrap tape around soldered area, a fray of twisted lines must be within 110 mm (4.

Bypass connection is never allowed repaired area, bypass connection may cause CAN communication error, spliced wire becomes separated and characteristics twisted, replace the applicable harness as an assembly if error is detected on the shield lines CAN communication line.

CAN COMMUNICATION SYSTEM : System Description, cAN (Controller Area Network) is a serial communication line for real time application, control units during operation (not independent), communication lines (CAN-H line, CAN-L line) allowing a high rate of information transmission with less wiring.

Each control unit transmits/receives data but selectively reads required data only, diag on CAN” is a diagnosis method which uses the CAN communication line communication between, the control unit diagnostic tool, dIAG ON CAN : System Diagram.

For communications with the diagnostic tool, cAN communication line between splice control unit, a point connecting a branch line with main line, circuit connected across the CAN communication system.

CAN communication signal is not transmitted or received between units for 2 seconds more, cAN communication line open (CAN-H, CAN-L, both), cAN communication line short (ground, between CAN communication lines, other harnesses), error of CAN communication control circuit of the unit connected CAN communication line.

WHEN DTC OF CAN COMMUNICATION IS INDICATED EVEN THOUGH CAN COMMUNICATION, removal/installation of parts: Error may be detected when removing and installing CAN communication unit, and related parts while turning the ignition switch ON, fuse blown out (removed): CAN communication of unit may cease.

Voltage drop: Error may be detected if voltage drops due to discharged battery when turning ignition, switch ON (Depending on the control unit which carries out CAN communication), error may be detected if the power supply circuit of the control unit, which carries out CAN communication, malfunctions (Depending on the control unit which carries out CAN communication).

Error may be detected if reprogramming not completed normally, cAN communication system is normal if DTC of CAN communication indicated SELF-DIAG, rESULTS of CONSULT under the above conditions.

Use of Cookies    About    Contact us
All marks are the property of their respective holders