2012 Nissan Juke - Heater & Air Conditioning Control System (Section HAC) (140 pages)

Posted on 25 Mar, 2015 by Krazyfrog
Model: 2012 Nissan Juke
File size: 1.88 MB


Other 2012 Nissan Juke Manuals:


Download manual 2012 Nissan Juke

Manual Description
HEATER & AIR CONDITIONING CONTROL SYSTEM, (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" 5, a/C UNIT ASSEMBLY : Aspirator 7, a/C UNIT ASSEMBLY : Intake Sensor 7.

A/C UNIT ASSEMBLY : Air Mix Door Motor 7, a/C UNIT ASSEMBLY : Mode Door Motor 8, a/C UNIT ASSEMBLY : Intake Door Motor 8, a/C UNIT ASSEMBLY : Blower Motor 8.

A/C UNIT ASSEMBLY : Power Transistor 8, cOMMON ITEM : CONSULT Function (BCM COMMON ITEM)26, aIR CONDITIONER : CONSULT Function (BCM AIR CONDITIONER) (Automatic A/C)27, mULTI DISPLAY UNIT, BCM, ECM, IPDM E/R.

DIAGNOSIS AND REPAIR WORK FLOW 37, pOWER SUPPLY AND GROUND CIRCUIT 67, inlet Port Memory Function (REC) 42, inlet Port Memory Function (FRE) 43.

DOOR MOTOR STARTING POSITION RESET 44, aIR CONDITIONER : CONSULT Function (BCM AIR CONDITIONER) (Manual A/C) 105, iNTAKE DOOR MOTOR : Removal Installation 93, mODE DOOR MOTOR : Removal Installation 93.

AIR MIX DOOR MOTOR : Removal Installation 94, dIAGNOSIS AND REPAIR WORK FLOW 108, (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" 95, a/C UNIT ASSEMBLY : Thermo Control Amp 97.

A/C UNIT ASSEMBLY : Blower Motor 97, a/C UNIT ASSEMBLY : Blower Fan Resistor 97, component Inspection (Blower Fan Resistor) 125, cOMMON ITEM : CONSULT Function (BCM COMMON ITEM) 104.

INTAKE DOOR CABLE : Removal Installation, mODE DOOR CABLE : Removal Installation, aIR MIX DOOR CABLE : Removal Installation, precaution for Supplemental Restraint System (SRS) "AIR BAG" "SEAT BELT.

The Supplemental Restraint System such as AIR BAG” and SEAT BELT PRE-TENSIONER”, used along, with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger certain, system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front, air bag, depending on the severity of a collision and whether the front occupants belted unbelted.

Information necessary to service the system safely is included in the SRS AIR BAG” and SEAT BELT”, always observe the following items preventing accidental activation, to avoid rendering the SRS inoperative, which could increase the risk of personal injury death, the event of a collision that would result in air bag inflation, all maintenance must be performed by.

Improper maintenance, including incorrect removal and installation of the SRS, can lead personal, injury caused by unintentional activation of the system, never use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual, pRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS.

When working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with, ignition ON or engine running, never use air or electric power tools or strike near sensor(s) with, when using air or electric power tools or hammers, always switch the ignition OFF, disconnect, battery, and wait at least 3 minutes before performing any service.

Refer to "ENGINE CONTROL SYSTEM , left side A/C unit assembly, instrument lower panel LH removed, back side A/C unit assembly.

Right side A/C unit assembly, the aspirator generates the vacuum by the air blown A/C, unit assembly and draws the air of the passenger room to the invehicle sensor area via aspirator duct.

Use of Cookies    About    Contact us
All marks are the property of their respective holders