Download manual 2010 Mazda Mazdaspeed 3Manual Description
his system allows you to lock and unlock the doors, even start, engine without taking key out, unlock the driver's door by pushing driver's, unlock all doors (and liftgate) by pushing.
Driver's door request switch once twice, (depending on personalization) OR by pushing, panic Alarm Lock all doors (and liftgate) by pushing any, open the trunk/liftgate by pushing electric.
Start the engine by pushing START/STOP button, while pushing the clutch pedal (manual transmission), or the brake pedal (automatic transmission), shut the engine OFF by pushing START/STOP button again.
Activate Accessories (ACC) by pushing START/STOP, button once without pushing the clutch brake pedal, will show green (engine ready start) when, the advanced key is detected and the clutch pedal (M/T) brake pedal.
If illuminated red, the START/STOP button may not start engine, unless, the auxiliary key is used (see Starting the Engine with Auxiliary Key”), nOTE: When the liftgate opener switch is pressed, the liftgate will open slightly, the liftgate is not opened within 1.
Lock) and the liftgate cannot be opened or closed from slightly raised position, to open/close the liftgate, press the liftgate opener switch, open liftgate within, this system remotely locks and unlocks the doors and liftgate, opens, the power windows moon roof.
Push & fold retract key, push and hold open trunk, continuously pushing START/STOP button while, the engine is running will turn engine OFF.
Only in case an emergency, if the advanced key cannot be used due malfunction, or dead advanced key battery, use auxiliary key, to lock/unlock the doors and start engine.
o start engine, locate the key slot cover, nsert the auxiliary key into the key slot, then push START/STOP, button with the clutch pedal (M/T) or the brake pedal (A/T) pushed, seat can be moved back forth.
Raised, lowered, or tilted with control, aise or lower seat height by, to Program Driver's Seat Position, djust seat to desired position using the Slide/Tilt Recline switches.
hile holding the SET button in, push one of three (3) programming, buttons until a beep is heard, nOTE: You can also program multiple seat positions each advanced key/retractable, type key used with the vehicle.
To Move the Seat Programmed Position, with driver's door OPEN and ignition OFF, push release one, of the programmed buttons (1, 2, or 3) when entering vehicle, with driver's door CLOSED and ignition ON, push hold one.
Of the programmed buttons (1, 2, 3), nOTE: Memory seat functions DO NOT operate when driver's door OPEN, ignition is ON, when driver's door is CLOSED and ignition is OFF, when vehicle, the driver front passenger seats.
Can be warmed by rotating applicable, seat warmer dial while ignition ON, (located on floor in front driver's seat).